铅丝笼的组装和编织 |
添加时间:2018/9/29 14:05:31 浏览次数: |
(1)镀锌大丝号六角网是采用优质低碳钢丝编织,钢丝的直径可达2.0mm-4.0mm,钢丝表面通常还采用热镀锌保护,镀锌保护层的厚度可根据客户的要求制做,镀锌量最大可达到300g/m2。
(1) No. six large galvanized hexagonal high quality low carbon steel wire braided wire, the diameter of up to 2.0mm-4.0mm, usually by galvanized steel wire surface protection, galvanized protective layer thickness can be made according to customer requirements, the largest amount of zinc can reach 300g/m2.
(2)镀锌丝包塑六角网是在镀锌铁丝的表面包一层PVC保护层,再编织成各种规格的六角网。这层PVC保护层将会大大增加在高度污染环境中的保护,并且通过不同颜色的选择,使其能和周围的自然环境相融合.
(2) galvanized wire, wrapped and plastic, six corners mesh, is coated with galvanized iron wire on the surface of a layer of PVC protection layer, and then woven into various specifications of the six corners of the net. This layer of PVC protection will greatly increase protection in highly polluting environments, and will be able to blend with the surrounding natural environment by varying color options
下列所有的测试必须在网丝被用于编织格宾网之前进行:
All of the following tests must be used before weaving mesh gabion mesh:
(1) 所有钢丝(包括制造格宾网片、绑扎丝) 的抗拉强度不小于515MPa。
(1) all wire (including manufacturing gabion mesh, binding wire) the tensile strength of not less than 515MPa.
(2) 伸长率: 试验样品至少30cm长, 伸长率不小于12%。
(2) elongation: the sample should be at least 30cm long and the elongation is not less than 12%.
(3) 镀锌钢丝的尺寸误差和镀锌量要求来电咨询。
(3) the size error and galvanized quantity of galvanized steel wire should be consulted by telephone.
(4) 锌层附着要求: 当镀锌钢丝环绕4倍于 钢丝直径的圆棒6周后, 用手指摩擦时, 镀锌层没 有剥落、断裂现象。 外包树脂膜( PVC): (1)抗拉强度不小于2016MPa。 (2)伸长率不小于200%。
(4) zinc coating requirements: when galvanized steel wire around 4 times the diameter of steel wire round bar, 6 weeks later, with finger friction, galvanized layer without spalling and fracture. The outsourcing of resin film (PVC): (1) the tensile strength of not less than 2016MPa. (2) elongation is not less than 200%. |
上一页 铅丝笼各方面的细节特色 |
下一页 铅丝笼各方面的细节 |
Copyright © 技术支持:遨游网络